Advertisement 
Advertisement
Send an email 
Huge source of knowledge about switchgear
Advertisement 
HV AC SwitchgearHigh Voltage Circuit BreakerVideos
Typical circuit breaker auto reclose in high voltage substation
Advertisement 
Thanks for sharing all of your experiences!
Your are welcome.
very useful. Thanks a lot
You are welcome
i don’t see the setting of reclaim time on some protection relay to make it auto reset the 79.
after the reclose time (cb on again), i can’t simulate to open the cb remotely (blocked).
any suggestion?
Hi
79 AC reclosing relay is a relay that controls the automatic reclosing and locking out of an AC circuit breaker.
The Reclaim time ranges from 0.1 seconds to 300 seconds. The reclaim time is a timer activated after a closing command is given causing the breaker to sends a tripping command if a fault is detected before the end of the time delay.
Most of digital relays I’ve seen have this option.
For example in Schneinder relays you must go to delays section and set time.
Thanks